Installation manual PUB107063A3771 Rev B Effective January 2019ContentsDescription PageKit contents 1Instructions for assembly 2Kit contents(3) 6-port lugs, (3) anti-rotation plates, (6) #6 plate screws,(3) mounting screws, (1) terminal shroud, (2) #4 x 1/2” hi-loscrews, (1) Warning / Torque Label, and (1) cover plateWire range 1/0-14 AWG (maximum 6) copper or aluminumwires.This kit is UL Listed (File E64983) for field installation on theloadside of the 400 A Frame Compact Circuit Protector (CCP)or 400 A CUBEFuse holder.Note: The purpose of these lugs is to distribute power to morethan one load and are to be installed only on the loadside.6-port multi-wire lug kit for use on 400 ACompact Circuit Protector and 400 A CUBEFuseholders Catalog no. CCP2-MW6-6TerminalshroudHi-loscrewsCover plateLugMounting screwPlatescrewAnti-rotation plateFigure 1HAZARD OF ELECTRIC SHOCK, EXPLOSION ORARC FLASHMAY RESULT IN DEATH OR SERIOUS INJURYWorking on or near energized circuits poses aserious risk of electric shock. De-energize allcircuits before installing or servicing this equipmentand follow all prescribed safety procedures.RIESGO DE DESCARGA ELÉCTRICA,EXPLOSIÓN O ARCO ELÉCTRICOPUEDE CAUSAR LESIONES GRAVES OINCLUSO LA MUERTETrabajar en o cerca de circuitos energizadosrepresenta un grave riesgo de descarga eléctrica.Desconecte todos los circuitos antes de realizaralguna instalación o de dar servicio a este equipoy siga todos los procedimientos de seguridadindicados.RISQUE D’ÉLECTROCUTION, D’EXPLOSION OUD’ARC ÉLECTRIQUERISQUE DE MORT OU DE BLESSURES GRAVESTravailler sur des circuits sous tension ou `aproximité pose un risque grave de choc électrique.Mettez tous les circuits hors tension avant d’installerou d’effectuer l’entretien de cet équipement etsuivre toutes les procédures de sécurité prescrites.