Eaton Bussmann Series Installation Manual

Also see for Bussmann Series: Installation manual Installation manual Instruction sheet Installation manual Installation manual

Eaton Bussmann Series Installation Manual Manual pdf 1 page image

Installation manual 3A3749 Rev B Effective October 2018Supersedes July 2018CCP2-FLC2-___ flange-cable operating mechanismHAZARD OF ELECTRIC SHOCK,EXPLOSION OR ARC FLASHMAY RESULT IN DEATH ORSERIOUS INJURYWorking on or near energized circuitsposes a serious risk of electricshock. De-energize all circuits beforeinstalling or servicing this equipmentand follow all prescribed safetyprocedures.• Do not install or perform maintenance onequipment while it’s energized.• Death, severe personal injury or substantialproperty damage can result from contactwith energized equipment. Always verifythat no voltage is present, and prescribedsafety and lockout/tagout procedures arefollowed.• Eaton is not liable for the misapplication ormis-installation of this product.• The user is cautioned to observe allrecommendations, warnings and cautionsrelating to personnel and equipment safety,as well as all general and local health andsafety laws, codes and procedures.• The recommendations and informationcontained herein are based on experienceand judgment, but should not beconsidered to be all-inclusive or coveringevery application or circumstance whichmay arise. If any questions arise, contactthe Bussmann Division for furtherinformation or instructions.General informationThese instructions cover the installation andoperation of the following Bussmann series flangecable operating mechanisms installed on 2- or3-pole versions of the fused 200 and 400 ampCompact Circuit Protector (CCP2) switches, and3-pole versions of the non-fused 200 and 400 ampCompact Circuit Disconnect (CCD2) switches.Catalog no. DescriptionNEMAratingCCP2-FLC2-36 36” Cable with paintedhandle 1, 3R,12CCP2-FLC2-36X 36” Cable with chromehandle 4XCCP2-FLC2-60 60” Cable with paintedhandle 1, 3R,12CCP2-FLC2-60X 60” Cable with chromehandle 4XCCP2-FLC2-120 120” Cable with paintedhandle 1, 3R,12CCP2-FLC2-120X 120” Cable with chromehandle 4XWhen installing the optional auxiliary contacts(cat. no. CCP2-AUX-225) with the flange cableoperating mechanism, the auxiliary contacts mustbe installed on the switch’s left side.ContentsDescription PageGeneral information 1Required tools 2Hardware contents 2Installation and adjustment 2-5Flange drilling pattern 6