Installation manual PUB106903A3769 Rev A Effective January 20193-port multi-wire lug kit for use on 200 ACompact Circuit Protector and 200/225 ACUBEFuse holders Catalog no. CCP2-MW2-3ContentsDescription PageKit contents 1Instructions for assembly 2Kit contents(3) molded insulators, (3) 3-port wire lugs, (3) 5/16-24mounting screws, (2) #6-19 hi-lo screws, (1) torque label,(1) terminal shroudWire range 2-14 AWG (maximum 3) copper or aluminumwires.This kit is UL Listed (File E64983) for field installation onthe loadside of the 200 A Frame Compact Circuit Protector(CCP) and 220/225 A CUBEFuse holders (TCFH_N).Note: The purpose of these lugs is to distribute power tomore than one load and are to be installed only on theloadside.Figure 1Figure 2MoldedinsulatorLugHi-lo screwsTerminal shroudMounting screwHAZARD OF ELECTRIC SHOCK, EXPLOSION ORARC FLASHMAY RESULT IN DEATH OR SERIOUS INJURYWorking on or near energized circuits poses aserious risk of electric shock. De-energize allcircuits before installing or servicing this equipmentand follow all prescribed safety procedures.RIESGO DE DESCARGA ELÉCTRICA,EXPLOSIÓN O ARCO ELÉCTRICOPUEDE CAUSAR LESIONES GRAVES OINCLUSO LA MUERTETrabajar en o cerca de circuitos energizadosrepresenta un grave riesgo de descarga eléctrica.Desconecte todos los circuitos antes de realizaralguna instalación o de dar servicio a este equipoy siga todos los procedimientos de seguridadindicados.RISQUE D’ÉLECTROCUTION, D’EXPLOSION OUD’ARC ÉLECTRIQUERISQUE DE MORT OU DE BLESSURES GRAVESTravailler sur des circuits sous tension ou `aproximité pose un risque grave de choc électrique.Mettez tous les circuits hors tension avant d’installerou d’effectuer l’entretien de cet équipement etsuivre toutes les procédures de sécurité prescrites.