Eaton Durant Eclipse 5775X-40 Series Installation And Operation Manual

Also see for Durant Eclipse 5775X-40 Series: Installation and operation manual

28PROGRAMMING cont.be quickly made aware via the display or a rate alarm output, of minor variations inflow rate. As the smoothing factor increases, the rate display gets progressivelymore stable. The best advice for the F7 value is to start at 1 and work up until the rateachieves a happy medium between response and steadiness.The rate zero timeout is the number of seconds between pulses that the ratemeterwill wait before making a zero calculation. If the rate smoothing factor is 1, the ratedisplay will go to zero if the time between pulses exceeds the rate zero time. Onesecond is normally a good number for flow applications.Column d - defaultsBlock Parameter Range (Default Value is Bold)d1 Power Up Display 0 Last1 Total low2 Rate3 Batch count4 Cycle countd2 Totalizer Display 0 10 digit totalMode 1 Totalizer ÷÷÷÷÷ 12 Totalizer ÷ 103 Totalizer ÷ 100d3 Reset Count 0 No resetCommands 1 Reset totalizer2 Reset batch count3 Reset totalizer and batch count4 Reset cycle count5 Reset totalizer and cycle count6 Reset cycle and batch counts7 Reset totalizer, cycle, and batch countsd4 Default Commands 0 No default action1 Default program values2 Default run values3 Default program and run valuesDepending upon model, options, and programming, there will be anywhere fromtwo to eleven different display screens that the operator can look at in the run mode.When the operator powers this up, what display should he see? Normally it will bethe last display he was looking at when he turned power off, in which case the d-1default setting of 0 is correct. However, the Eclipse can be programmed to alwayspower up to the totalizer display. Batchers have, in addition, the ability to power up torate, batch count, or cycle count.