Eaton Evolution 650/650 Rack 1UEvolution 850 Installation And User Manual

Also see for Evolution 650: Installation and user manual Installation and user manual Quick start guide Installation and user manual Installation and user manual

Contents

3.4 UPS ShutdownPress button (10) for approximately 2 seconds.The devices connected to the UPS are no longersupplied.3.5 UPS Remote Control55K6U.P.S.RAC OUTPUTI max 12AAC INPUTFAULTSITE WIRINGU.S. PAT. NO. 6,094,36336Vdc, 9AhPb21 Programmableor RS232ROO RPO7Evolution offers a choice between two remote controlfunctions.w RPO: Remote Power OFF allows a remote contact tobe used to disconnect all the equipment connectedto the UPS. Restarting the UPS requires manualintervention.w ROO: Remote ON/OFF allows remote action ofbutton (10) to shut down the UPS.These functions are obtained by opening of the contactconnected between the appropriate pins of connector(7) on the rear panel of the UPS (see figures below).Remote control connection and test1. Check that the UPS is OFF and disconnected from the AC input source.2. Remove connector (7) after unscrewing the screws.3. Connect a normally closed volt-free contact (60 V DC / 30 V AC max., 20 mA max., 0.75 mm² cablecross-section) between the two pins of connector (7) (see diagram).Contact open: UPS shutdownContact closed: UPS start-up (UPS connected to ACpower and AC power is available).Note: The local ON/OFF control using button (10)overrides the remote-control function.Contact open: UPS shutdown, LED (14) goes ON.To return to normal operation, deactivate the remoteexternal contact (LED (14) goes OFF) and restart theUPS by pressing button (10).4. Plug connector (7) into the back of the UPS.5. Connect and restart the UPS following the previously described procedures.6. Activate the external remote shutdown contact to test the function.Warning: This connector must only be connected to SELV (Safety Extra-Low Voltage) circuits.3. Operation86-81700-00EN A02 - Page 18