Eaton IQ 200 Installation, Operation And Maintenance Manual

Contents

Page 34 TD 17558Effective 3/98Figure 4.17 Password Entry4.10 EDIT SETPOINTS (3 and 4 wire systems)This menu selection permits the user to change all of the IQ 200 setpoints andsystem parameters.Press Menu to display the list of available items.Position the selection arrow next to Edit Setpoints and press Enter.If the Password option has been enabled, the system requests the password via thescreen shown in figure 4.17.To enter the password, press Enter to move theunderline to the desired digit. Then use the Scroll uparrow to increase the digit or the Scroll down arrow todecrease the digit. When the desired choice isdisplayed, press Enter to lock in the selection.If an incorrect password is entered, the message Password Incorrect displays.Press Menu to return to the previous screen showing Edit Setpoints selected. PressEnter to retry entering the password.If the correct password is entered, or if the Password option is not enabled, thefollowing screens display:4.10.1 Edit AllThis menu item displays all of the setpoints described in sections 4.10.2 through4.10.10. To edit only one setpoint, follow the steps under the appropriate section.Selecting the Edit All menu item displays the screens shown below as the Scrolldown arrow is pressed. (Note: the lagging or leading indicator and any signs may bethe opposite of that shown in the sample screens.)Position the selection arrow next to Edit All and press Enter.The following screens display:4.10.2 Password SetupPosition the selection arrow next to Password Setup and press Enter.This screen, shown in figure 4.18, allows the user tospecify if a password is required to change theIQ 200 setpoints or system parameters and whatthe password is or would be if it were in use.The screen initializes with Use Passwordselected and the current choice displayed. To Figure 4.18 Password Setup