Conversion kit LED6DEFINITION OF ORDER CODES:Indicating LED Cable:__ : having indicating LED onlyTB: having indicating LED and NC Test ButtonRemote connection:_: TelecommandCGL: Connection for CGL+ busD: Connection for DALI busBattery cell number / size:4AA: NiCd AA/0.8AhxCS: NiCd CS/1.7Ah (3 or 4 or 5)xD: NiCd VTD/4Ah (3 or 4)2L: LiFePo4/3.2AhConverter output voltage range:L: Low voltage range 3..33Vdc (SELV)M: Medium voltage range 20..55Vdc (SELV)H: High voltage range 40-180VdcTECHNICAL SPECIFICATIONS:System Mode Non-MaintainedMains input voltage 230 V AC ±5% (218,5 - 241,5 V AC)Mains frequency 50/60HzMains Consumption 20mA AC max @ AA & L cell battery30mA AC max @ CS & D cell batteryPower factor 0,47Recharge period 24 hours / 16 hours on 2h variants*on LiFePo variants charging temperaturerange is between 0 oC..50oC(battery protection)Charging monitor Green LED with cable 1mBi-color LED (Green/Yellow)with cable 1m - CGL+Bi-color LED (Green/Red) withcable 1m - DALITest facility by Normally Closed Push buttonby Normally Open Push button*by Telecommand signal**not applicable on CGL+/DALI variantsDuration 1 or 3h, selectable by jumper,2h/3h only variants availableAmbient temperaturerange (t a) 5..40°C / 5..50°C (LiFePo)Case temperature max (tc) converter: 60°C battery: 50°CIP rating 20Overheating protection 110°CShort circuit protection Non-inherently short circuit proofWeight 125grSTANDARDS:Complies with: EN 61347-1, EN 61347-2-7,EN 55015, EN 61547, EN 61000-3-2According to: EN 60598-2-22,EN 61347-2-13, RoHSOVERVIEWConversion kits allow your existing fitting to provideup to 3 hours of emergency lighting in the eventof a power failure. They are easily installed withinthe existing fitting or in specially designed externalmounting enclosures. The kits are available for LEDlamps operating on the range of 3 to 180Vdc.PREPARATIONBefore using the converter, plan you conversioncarefully, read this leaflet and follow the instructionsgiven in order to comply with current legislation. It isInstallation Instructions