MEMSHIELD 4 INSTALLATION INSTRUCTIONS FOREM4PBKEL404/EM4PBKEL804 EARTH LEAKAGE MODULESInstruction leaflet LT1227 (01/19)IMPORTANT NOTES1. This product should be installed, commissioned and maintained by or under the supervision of a competent electrician inaccordance with current electrical engineering Codes of Practice, Requirements for the Electrical Installations (IET WiringRegulations BS7671), Construction (Design and Management) Regulations, HSG150 - Health and Safety in Construction, Statutoryrequirements and any Specific instruction issued by the Company.2. After completing the installation and testing of this product it is essential that this leaflet is drawn to the attention of theperson responsible for its future operation and maintenance, and is at all times available for ready reference.3. These notes assume throughout that the product is disconnected from the supply. It is essential that this is done before anywork is carried out.4. These Panelboards are only designed for use with Eaton MCCBs. Failure to comply will result in invalid warranty andcertification.Items supplied with Earth Leakage ModulesM8 x 16mm long screw 2 QtyM8 Hexagon Nut/washer 2 QtyM6 x 16mm long screw 4 QtyM6 Hexagon Nut 4 QtyM6 External Tooth Washer 8 QtyM5 x 8mm self tapping screw 2 QtyCable Ties 12 QtyCable Tie Bases 4 Qty2.5mm² Double Insulated Grey/Brown) Cable 2.8 metres2.5mm² Double Insulated Grey/Blue Cable 2.8 metres2.5mm² Cable Ferrules 2 Qty2.5mm² x M8 Ring Connector 2 Qty1.5mm² Grey Cable 2 metres1.5mm² Cable Ferrules 6 QtyShunt Trip 1 QtyEarth Leakage Module assembly instructions1. Align the Module to the bottom of the Panelboard and fix together with provided screws: 4 x M6 screws and nuts; 8 x externaltooth washers on either side of the joint to break the paint for earth continuity.2. Fit the Shunt Trip provided to the incoming MCCB.3. Fit the terminal block assembly (Fig.1) to the Panelboard. Using the DIN rail as template, mark the position of the 2 fixingholes. Drill 2 x 4.3mm dia holes and secure the terminal block assembly using the M5 x 8mm screws provided.Fig.1 Terminal Block Assembly