Eaton NOVA STS-15 Installation And Operation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Contents

Eaton NOVA STS-15 Installation And Operation Instructions Manual Manual pdf 9 page image

4NOVA™ STS Single-Tank,Triple-Single,Electronically ControlledRecloserINSTALLATION AND OPERATION INSTRUCTIONS MN280046EN May 2016Installation procedureWARNINGHazardous voltage Always use a hotstick when workingwith this equipment Failure to do so could result incontact with high voltage, which will cause death orsevere personal injury G108 1WARNINGThis equipment is not intended to protect humanlife Follow all locally approved procedures and safetypractices when installing or operating this equipmentFailure to comply can result in death, severe personalinjury, and equipment damage G102 1When installing the recloser, refer to the applicable reclosermounting frame instructions. Installation instructions areincluded with the mounting frame.1. Check the data plate ratings. Make sure the ratings,settings, and interface options on each recloserdata plate (see Figure 2) are correct for the plannedinstallation.Figure 2 NOVA STS recloser data plate2. Perform high-potential withstand tests. Prior toinstalling the NOVA STS recloser, perform high-potentialwithstand tests. Refer to the Service informationsection for high-potential withstand test procedures.This test will help identify any shipping damageaffecting the dielectric condition of the recloser or thevacuum integrity of the interrupter.CAUTIONPersonal injury Sheds on epoxy encapsulation havesharp edges Wear protective gloves when handling theunit Failure to do so can result in cuts and abrasionsT258 13. Install the recloser. Install the recloser in theappropriate Eaton’s Cooper Power series pole- orsubstation mounting frame. See Figure 3 for movingand lifting instructions.WARNINGFalling equipment Use the lifting lugs provided andfollow all locally approved safety practices when liftingand mounting the equipment Lift the unit smoothlyand do not allow the unit to shift Improper liftingcan result in severe personal injury, death, and/orequipment damage G106 3Moving the recloserThe NOVA STS reclosers are shipped palletized (bolted ontoa pallet). When moving with a fork truck/lift, the reclosermust remain bolted to the pallet to avoid damage.Eaton recommends transporting Cooper Power series NOVAreclosers in the closed position to maximize the operationalperformance of the unit.Lifting the recloserFollow all approved safety practices when making hitchesand lifting the equipment. Lift the unit smoothly and do notallow the unit to shift.CAUTIONTip-over hazard High center of gravity Use a 4-pointhitch to prevent switchgear from overturning duringlifting operations Improper lifting can result in personalinjury or equipment damage T297 0OPENCLOSEACgBLiftingLugsOPENOPENA: Sling height for 15 kV and 27 kV with 125 BIL units: 914 mm (36 inSling height for 27 kV with 150 BIL and 38 kV units: 1067 mm (42 in)B: Center of gravity (Cg) is approximately 254 mm (10 in) below plane oflower terminals.Figure 3 Moving and lifting the NOVA STS recloserWARNINGHazardous voltage Solidly ground all equipment Failureto comply can result in death, severe personal injury,and equipment damage T223 2