Eaton PXG 900 User Manual

PXG 900 User's Guide - Firmware Version 4.3 - 1/9/201725BACnet IP ServerSetting up a BACnet/IP ServerNote: Edit must be active to make these changes. The Base ID setting won't be reflected in the DeviceMapping until you save and exit edit mode.If you enable BACnet/IP. you can present the connected devices as virtual devices on a BACnet/IP virtual network.Routed Network NumberYou must provide the Routed Network Number that will be assigned to the virtual network. Possible values are 1through 65534. Ask someone in your facility maintenance group that is responsible for maintaining the BACnetnetwork infrastructure for guidance in selecting a Routed Network Number. The Routed Network Number must beunique from all other BACnet network numbers within the BACnet global network.Caution: If you choose a Routed Network Number that is already in use, communications problemswill result.Base ID for Auto-AssignThis is the base ID value used by auto-assign (if enabled) to assign the gateway and virtual device instancenumbers.Auto-Assign Gateway IDIf enabled, the ID for the gateway is automatically assigned. If you set a Base ID, the gateway will be the base valueplus one. If disabled, you can manually set the ID by clicking View Map.Auto-Assign Device IDsThe various virtual device IDs will be assigned based on the Base ID (if specified) and incrementing from the IDassigned to the gateway. If disabled, you can manually set the IDs by clicking View Map.BACnet Broadcast Management DeviceIf you're using a BACnet Broadcast Management Device (BBMD) to connect your meter to another subnet in yourBACnet/IP network, you must also define the BBMD IP address (IPV4 only) to register with the BBMD on the remotesubnet. You can also set the BBMD Time to Live value in seconds.