Eaton Power Xpert Gateway 900 Quick Start Manual

Also see for Power Xpert Gateway 900: Quick start guide Installing Installation, operation & maintenance manual

Contents

Power Xpert Insight GatewayQuick Start Guide12To specify a static IP address:1. Enter the IP Address for the PXG900.2. Enter the IP address information for your network, includingthe Subnet Mask, Gateway, and one or more DNS servers.Separate the DNS server addresses with a comma.3. Choose Save Configuration.To use DHCP to assign an IP address:1. Select DHCP Enabled.2. Choose Save Configuration.Choose Edit again to exit edit mode. After you’ve completed con-figuring an IP address (either through DHCP Reservations or as astatic IP), write this on the label under the connectors.SettingsUnder Settings, you can configure:• Date and Time• Localization• Access Control (enable/disable ports and enable trustedhosts)• Modbus TCP (if enabled)Look in the upper right of the screen to access Settings.Preferences TabDate and TimeIf time stamp accuracy on data is important to you, NTP syncroni-zation is the best option. However, you’ll either need access tothe Internet or you’ll need to install an NTP server on your net-work. The PXIG will periodically check the time and correct itself.If you want to set the clock to match that of the PC you’re usingto configure the software, just choose this option. Otherwise, setthe time and date manually. The manual setting pop-out windowwill also let you sync the gateway to your PC clock.