Eaton Power Xpert Gateway 900 Quick Start Manual

Also see for Power Xpert Gateway 900: Quick start guide Installing Installation, operation & maintenance manual

Contents

technical information

2Technical Data TD150022ENEffective October 2017Power Xpert Gateway 900 Advanced ColorTouchscreen Display Quick Start GuideEATON www.eaton.com4. Insert the PXG 900 Advanced Display through the cutout. Afterthe display is inserted into the front side of the cutout, securethe display by attaching the eight supplied fasteners to the rearperimeter of the display.Figure 4. PXG 900 Advanced Display fasteners.5. Check for proper alignment of the PXG 900 Advanced Displaythen torque fasteners to 7 lb-in. (0.8 N·m).Figure 5. PXG 900 Advanced Display fasteners - installed.Setting up the PXG 900 for displayIn order for the display to function properly, the Power XpertGateway 900 (PXG 900) must not timeout after inactivity. This set-ting can be changed by following the instructions below.1. Begin by installing the Power Xpert USB configuration driveron your PC. The driver and instructions can be found atwww.eaton.com/pxg2. Connect the PXG 900 to a PC with the accompanying USB cord.3. With a browser, visit the IP address 192.168.200.101.4. Select Settings >Security >General >Edit.5. Set the Session Timeout to 0.6. Click the Save button.Figure 6. Editing session timeout.The display requires an account with the user name and a passwordof the user. This account exists by default. This can be confirmedwith the instructions below.1. With a PC connected to the PXG 900 via USB, navigate to192.168.200.101.2. Select Settings > Security > User Configuration. All existing useraccess credentials are shown.