Eaton Powerware Series Quick Start Instructions

Also see for Powerware Series: Installation and operation manual User guide User guide User guide User guide

Contents

install the card

Figure 9. Configure Card SettingsFigure 10. Set ConnectUPS Card IP AddressFigure 11. Save and ExitFigure 12. ConnectUPS Card Summary PageEaton ® ConnectUPS Web/SNMP Card (X and BD Models) Quick Start Instructions 164950185 Rev Bwww.eaton.com/powerquality7Section 3Configure the CardTo configure the card after you have connected it:1. Type 1 on the Main Menu to display the Web/SNMP CardSettings screen (see Figure 9).2. Type 1 to display the Set the IP Address, Gateway Addressand MIB System Group screen (see Figure 10).3. To set the IP Address, type 1 and press Enter. Type the IPAddress and press Enter. (see the Checklist).4. Type 0 to return to the previous menu.5. Repeat Steps 3 and 4 to set the Gateway Address andNetwork Mask.6. Change any other options as needed for your particularconfiguration by typing the corresponding number shown inthe menu.Each Configuration Menu setting is described in detail inthe Appendix of the ConnectUPS Web/SNMP Card User'sGuide. You can change the other options later if you prefer.7. Type 0 until you return to the Main Menu (see Figure 11).8. Type 0 to save all settings and exit the card configuration.9. Verify network communication by using a Web browser (seeFigure 12). Type the IP Address of your card and select Go.The ConnectUPS Card summary page opens.NOTE Once the card is reachable on the network, you canuse a Web browser, Telnet, or similar utility to adjust any ofthe configuration settings. The menus are identical to thoseseen during serial configuration and are password-protectedfor Superuser access only.