Eaton RI-2 Installation Manual

Contents

Eaton - Lighting Systems iLight Product Series - RI-2 73-897-00 IM8791 Iss 5 48 Analog / digital inputsIndividually programmable as analog or digitalinputsAnalog input mode:• Suitable for use with rotary and linearvariable resistors• Reads input voltages from 0 – 10 VDC• Inputs protected for use up to 12 VDCDigital input mode works with:Switch closure from the IN to Common• For use with both momentary andmaintained inputs• Minimum momentary input pulseduration20 msec• Switch will see up to 60uA when closedOpen collector NPN active low circuit• On-state voltage ≤ 500mV and capable ofsinking 60uA• Collector-emitter leakage current ≤ 10 uA• Collector-emitter voltage ≥ supply voltageActively driven circuit• Active low voltage ≤ 500mV andcapable of sinking 60uA• Active high voltage ≥ supply – 1 volt• All analog / digital inputs wire with 2part connectors with screw terminals.Wire sizes 12 AWG (4mm2) to 24 AWG(0.25mm2).8 Relay Outputs• Can be wired to provide low voltage orline voltage outputs.• Do not mix low voltage and line voltageon relay output terminals• Normally open and Normally closedterminals available for each relay• Low voltage volt free outputs• Line voltage rated at 3 Amps AC forgeneral use, resistive, incandescentlamps (tungsten), electric discharge(ballast) loads and ¼ HP AC motor loadsfor use at 120 VAC.• LED diagnostic indicators for relay status8 Digital Outputs• LED indication of switched output status• Configurable as digital control channels• Outputs will drive a single LED, or twoLEDs in a series with up to 20mA ofcurrent; exact current will depend uponthe forward voltage drop of the LED used.• Outputs are actively driven high and lowto TTL voltages with an internal seriesimpedance of 220 ohms.• All digital outputs wire with 2 partconnectors with screw terminals. Wiresizes 12 AWG (4mm2) to 24 AWG(0.25mm2).Support for multiple control protocols• 2 sets of terminals for the iCANnetnetwork• RS485 connection to third party devices• DMX 512A output to third party devices2 Alarm switch inputs• For integration with emergency controldevices and building managementsystems• For DC use only• Maximum open circuit voltage, 5V