Eaton Sure-Lites SELW29SD Installation Instructions Manual

Installation Instructions for the Sure-Lites SELW29SD Emergency Light withSelf DiagnosticsWARNINGRisk of Fire / Electric ShockIf not qualified, consult an electrician.Important SafeguardsWhen using electrical equipment, basic safety precautionsshould always be observed including the following:• READ AND FOLLOW ALL SAFETY INSTRUCTIONS• Do not use in hazardous locations, or near gas or elec-tric heaters.• Do not let power supply cords touch hot surfaces.• Use caution when servicing batteries. Battery acid cancause burns to skin and eyes. If acid is spilled on skinor in eyes, flush acid with fresh water and contact aphysician immediately.• Do not use this equipment for other than the intendeduse.• Installation is to be performed only by qualified person-nel.• Install in accordance with National Electric Code andlocal regulatory agency requirements.• The use of accessory equipment not recommended bythe manufacturer may cause an unsafe condition.• Equipment should be mounted in locations and atheights where it will not readily be subjected to tamper-ing by unauthorized personnel.• SAVE THESE INSTRUCTIONSWARNINGRisk of Electric ShockDisconnect power at fuse or circuit breaker before installingor servicing.INSTALLATION1. De-energize the circuit at the junction box (J-box)where the emergency light is to be installed.2. Open the emergency light by inserting a flat screw-driver in the two slots on the side of the unit, thenturning to separate housing from the backplate.3. To mount to a junction box - Drill out the appropriatemounting pattern and the wire pass hole in the back-plate and the back gasket to fit the J-box being used.4. To mount to conduit – Unscrew the ½” NPT plug locat-ed at the top of the fixture and screw in the user-sup-plied conduit hub.5. Once the backplate is secured, the housing can beheld in place during installation with the help of the twoplastic strips (see Fig. 1 next page).6. Connect the incoming wires to the SELW29SD powersupply wires using the wire nuts provided. Connect thewhite wire to neutral. If using 120V, connect the blackwire to the hot lead. If using 277V, connect the orangewire to the hot lead. Cap the unused lead. Secure theemergency light to the wall and/or junction box usinginstaller supplied hardware.7. Complete the battery connection and snap the coveronto the backplate.8. Energize AC supply. The test button should illuminate,and LED heads will illuminate briefly when the testbutton is pushed.9. Adjust the heads as needed. The SELW29SD lensesutilize a highly directional beam, and the lenses can berotated to adjust the beams to the front or sides of thefixture (see Fig. 2 next page).Sure-Lites049-282

/ 4

Related manuals for Eaton Sure-Lites SELW29BZSD