4213Installation Instructions for:Zeta 3 IP65 Product luminaires comply with EN60598 and are suitable for use in normal interior/exterior conditions.o o This luminaire has an ambient temperature range of 5 C to 25 C.Cable EntryNOTE: If the fitting is required to be IP65 rated, ensure a suitable IP65 rated cablegland is used to seal cable entry.For BESA entry or fixing points, fit to a flat surface. Sealant or suitable sealingwashers should be applied around fixing screw heads to maintain the ingressprotection of the luminaire.Cable Entry withBesa entry availableCable EntryCable EntryOptional GasketIf fitting is required to be IP65 rated,ensure gasket is fitted around outsidegroove. If not required, please discard.Fitting the Legend (Ordered separately)Self adhesive legendscan be fitted to thefront face, usesoapy water toposition correctly.Take base of fitting, knock through the preferred cable entry point.Note: Centre cable entry requires drilling. Using the hexagonalpattern, knock out suitable points and mount to fixing surface, ifwall mounted ensure battery clips are at the bottom of the fittingUsing a screwdriver, release 4 x clipsand remove transparent lid.Remove the battery and gasket fromthe base.Clip battery back into positionFeed mains cablethrough cable entryand wire the PCB onthe lid as per below,connect the batterylead to the PCBRefit lid on to the base, ensuring thecapacitors are the opposite side tothe battery in the base. Ensure tabsare fully fastened to ensure IP ratingZeta 3 can be operated inMaintained or Non-Maintainedmode by cutting or removing thelink on the PCB.Note: There is 'no' switchedinput supply to the luminaireand therefore cannot be remotelyswitched between maintainedand non-maintained operation.Link WireTerminal Block:L - Live (Brown)N - Neutral (Blue)WiringENSURE ALL 4 CLIPS ARE RELEASED,FORCING OPEN WITH ONLY 2 CLIPSOPEN WILL DAMAGE THE OTHER CLIPS