Eaton i-on30EXL Installation Manual

i-on30EXL/EXDL InstallationPage 29Step 10. Fit and ConnectBatteryIt is possible to fit either a 7Ah or 17Ah Lead Acidbattery into the battery compartment in the bottomof the control unit (see Figure 56).When fitting a 17Ah battery, use a battery whosecase material has a minimum rating of UL94V-2 inorder to comply with EN60950 (this standardapplies because of the energy content of 17Ahbatteries).See page 12 for example calculations of batteryrequirements.WARNING 17Ah lead acid batteries weigh 6kgeach. Do NOT drop. Ensure that the fixings of thecontrol unit case to the wall, and the wall itself, arestrong enough to support the weight of the controlunit, its lid and a 17Ah lead acid battery. The totalweight of the control unit plus batteries can be upto 11kg.Connect the battery leads, red to the positive,black to the negative terminals of the battery.Connect the other ends of the leads to BATT (15on Figure 3).Figure 56 Fitting a BatteryNote: Connecting the battery without mains powerwill not start the system. (See “ProgrammingBefore Installation” in the i-on Range EngineeringGuide.)Step 11. Initial Power-UpPlease see the i-on Range Engineering Guide foran explanation of bus addressing.WARNING: During initial power-up all the keypadsounders, internal loudspeakers and wired sirensMAY give an alarm tone. If you are working at thetop of a ladder make sure that the sudden noisedoes not startle you and cause a fall.1. Apply mains power to the control unit.The keypads and internal sounder may givean alarm tone. The heartbeat LED on thecontrol unit PCB (see 13 on Fig 3) startsflashing. The navigation keys on any attachedkeypad start flashing.All connected keypads briefly show thesoftware revision of the keypad itself, followedby the words “Please wait...” for severalseconds while the control unit scans the bus.When the control unit has finished scanningthe bus the keypads show:2. Press and hold keys A and  simultaneouslyon the keypad that you wish to use for initialprogramming. NOTE: Hold the keys downfor at least three seconds.After a short pause the keypad gives aconfirmation tone. The display briefly showsthe bus address of the keypad. If there are noother keypads connected to the bus it shouldbe “b1-d51”(bus 1 device 51). Keypads takebus device addresses 51 upwards.(If you are installing a UK control unit pleasego to step 6.)On an EUR control unit the keypad displaythen shows:3. Press  or  followed by  to select thelanguage you want. (In the i-on30EXL/EXDLEnglish is the only language available.)From this point on, the display operates in theselected language. If you want to change thelanguage later use Installer Menu - SystemOptions - Language.On an EUR control unit the display shows:4. Press  or  to show other countries, forexample5. Press  to select the country you wish to use.The display shows:6. Press A or B to select either a Partitionedsystem or a Part Setting system.Note: To change to Partition or Part Set mode at alater date you will have restore factory defaults.7. Press  or  to show the range of zonewiring types available, for example:8. Press  to select the wiring type you intend touse for the wired zones.Note: This initial choice fixes the wiring type forthe control unit and any attached wiredexpanders. If you wish to use a different wiring