Eaton i-on50EX Installation Manual

Also see for i-on50EX: Quick user guide Administrator's and user guide

i-on50EX/EXD InstallationPage 19LEDs are enabled. Forexample:3. Leave local programmingmode and save yourchanges (see page 19).To Change Backlight Settings1. Enter Local Programmingmode (see above)MENUABCD 2. Press . The display showsthe current status of thebacklight LEDs, forexample:MENUBACKLIGHT 3. Press  repeatedly to selectone of the following:Backlight LEDs ON (). MENUBACKLIGHT Backlight timed ().The backlight will glow for12 seconds after the lastkeypress. The action ofthe backlight depends onthe programming of thecontrol unit (which musthave Release 3 or highersoftware installed).MENUBACKLIGHT 4. Leave local programmingmode and save yourchanges (see below).To Disable/Enable the Status OK LED1. Enter Local ProgrammingmodeMENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS OK LED 3. Press  repeatedly toselect one of thefollowing:Status OK LED ON (). MENUSTATUS OK LED Status OK LED OFF ().The green status LEDunder the navigation keywill glow for 20 secondsafter the last press (thismay be useful when thekeypad is placed inbedrooms that should becompletely dark at night).MENUSTATUS OK LED 4. Leave local programmingmode and save yourchanges.To Disable/Enable the Status FaultLED1. Enter Local Programmingmode.MENUABCD 2. Press  repeatedly untilthe display shows:MENUSTATUS FLT LED 3. Press  repeatedly toselect one of thefollowing:Status Fault LED ON (). MENUSTATUS FLT LED Status Fault LED OFF().The red Fault LED underthe navigation key isdisabled, and will notglow for any fault reports.MENUSTATUS FLT LED 4. Leave local programmingmode and save yourchanges (see below).To Leave Local Programming Modeand Save ChangesEITHER:Press ORClose the keypad tamper.The keypad saves the changes you have made inits local memory.You can now remove 12Vdc power, if required, orleave Installer Menu on the control unit.KEY-EP External Prox ReaderFigure 29 shows the outside details of the externalprox reader KEY-EP:1. LED window.2. Retaining Screw.3. Removable Fixing Plate.4. Permanently attached cable.Figure 29 External Prox Reader KEY-EP2341