Ebyte E70 Series User Manual

Ebyte E70 Series User Manual Manual pdf 23 page image

CC1310 Wireless Module E70 Series User ManualCopyright ©2012–2017, Chengdu Ebyte Electronic Technology Co., Ltd. 23 / 346.8 Power Saving Mode (Mode 6)Status M0=0 M1=1 M2=1Transmitting Transmission is not available.Receiving Receiving is available.Baud rate & airdata rateUnder this mode, the baud rate and air data rate are independent, both receiver and transmitter can have differentbaud rate but same air data rate.AdvantageThe module works under WOR status, it wakes up periodically and monitors the wireless data packets, when datapacket monitored, the module enters receiving mode and receives complete data packets, and outputs the datathrough serial port, and then enters WOR status again, which can save power consumption significantly.Disadvantage Transmission is not available under this mode, the module must be switched to other mode for data transmission.Applications Applicable for those devices which have requirement on power consumption and need to receive data.Note It can only receive the data sent from the transmitter under mode 4.6.9 Sleep Mode (Mode 7)Status M0=1 M1=1 M2=1Transmitting Transmitting is not available.Receiving Receiving is not available.Others Other functions of the module are closed, only can quit sleep mode by switching the M0, M1 and M2 status.7.Instruction FormatIn configuration mode（Mode 3：M0=1, M1=1, M2=0）, it supports instructions below.(Only support 9600 and 8N1 format when setting)No. Instruction format Illustration1 C0 + working parametersC0 + 5 bytes working parameters are sent in hexadecimal format. 6 bytes in total and must besent in succession.( Save the parameters when power-down )2 C1+C1+C1 Three C1 are sent in hexadecimal format. The module returns the saved parameters and mustbe sent in succession.3 C2 + working parameters C2 + 5 bytes working parameters are sent in hexadecimal format. 6 bytes in total and must besent in succession. ( Do not save the parameters when power-down )4 C3+C3+C3 Three C3 are sent in hexadecimal format. The module returns the version information and theymust be sent in succession.5 C4+C4+C4 Three C4 are sent in hexadecimal format. The module will reset one time and they must be sentin succession.