Ebyte E810-DTU User Manual

Also see for E810-DTU: User manual User manual User manual User manual User manual

Ebyte E810-DTU User Manual Manual pdf 12 page image

Chengdu Ebyte Electronic Technology Co.,Ltd E810-DTU(CAN-ETH) User ManualCopyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd 122.4.4.UDP Client instruction1.Set "Network Debugging Assistant" to UDP (this host does not distinguish UDP Client from UDP Server), local host IPset to 192.168.4.100, and local host port number set to 8887.2. Set the network type of SOCKET A1 network type to UDPC (UDP Client), the target IP address is 192.168.4.100, andthe destination port is 8887. Click Save to restart the module.3.Open the CAN analyzer software, select the correct COM port and baud rate, and click the "Network DebuggingAssistant" to connect the device for communication test.The below picture shows a standard data frame sent by the network. The ID is 0x00 0x00 0x06 0x66 and the data is 0x010x02 0x0A 0x0B 0x0C 0x0D 0x0E 0x0F. The data received by the network conforms to the data format. (see the basicfunction of CAN-Data Protocol for details).