Echo GT-225i Operator's Manual

Also see for GT-225: Operator's manual Parts catalog Parts catalog Operator's manual Operator's manual

14 X7722273204© 04/2013 ECHO Inc.ASSEMBLY GT-225Nylon Line Installation1. Shut engine off. Lay unit on the ground with head assemblyup.2. Remove old nylon line through center recess of head.3. Thread new lines through outside holes (A) in housing untilends meet in center of recess.Note: Insert cutting line ends to center of head recess to insureeasy removal of used lines.Front (Loop) HandleNote: Label shows minimum spacing for front handle location.Note: Front handle is pre-installed. Re-positioning andtightening is all that is required.1. Position front handle (A) in comfortable operating positionand tighten wing nut (B). The cutting attachment should be5-7.5 cm (2-3 in.) above the ground and as level as possible.AMINSPACINGAB