Echo Power Pruner PPF-210 Operator's Manual

Also see for PPF-210: Installation and operating instructions Operator's manual

POWER PRUNER TMOPERATOR 'S MANUAL 15ACOPERATIONSTARTING COLD ENGINEWARNING DANGERThe attachment will operate immediately when the engine starts andcould result in loss of control and possible serious injury. Keepmovable parts of the attachment off the ground and away fromobjects that could become entangled or thrown.1. Stop SwitchMove stop switch (A) forward away from the STOP position.2. ChokeMove choke (B) to “Cold Start” ( ) Position.3. PrimerPump primer bulb (C) until fuel is visible and flows freely in theclear fuel tank return line. Pump bulb an additional 4 or 5 times.WARNING DANGERInspect starting area for hazards such as rocks, glass, debris etc.which could be contacted by the cutting attachment when starting.Keep helpers and bystanders at least 15 m (50 ft.) from starting area,otherwise serious personal injury may result.4. Recoil StarterLay the unit on a flat area and keep movable attachment parts clearof all obstacles. Firmly grasp right hand grip and throttle triggerlockout with left hand and fully depress throttle trigger to wideopen position. Rapidly pull recoil starter handle/rope (D) untilengine fires (or maximum five [5] pulls).5. ChokeAfter engine fires (or five [5] pulls), move choke lever back to“Run” ( ) position. Hold throttle trigger and throttle triggerlockout fully depressed and pull recoil starter handle/rope untilengine starts and runs. Release throttle trigger and allow unit towarm up at idle for several minutes.NOTEIf engine does not start with choke in “Run” position after 5 pulls,repeat instructions 2 - 5.6. After engine warm up, gradually depress throttle trigger to increaseengine RPM to operating speed.BD