Echo SMR-2110 - 01-99 Operator's Manual

Contents

GRASS TRIMMER /BRUSH CUTTEROPERATOR ' S MANUAL 15THROTTLE LINKAGE AND IGNITION LEADSTools Required: 8mm x 10mm open end wrench (all models), 3mm AllenWrench.1. Close choke and remove air filter cover.2. Loosen nut (A) and place threaded end of throttle linkage inbracket slot. Finger tighten nut (A).3. Place inner cable in slot of carburetor swivel (B) and tightennut (A).4. Check throttle for freedom of movement and make sure it returnsto idle position. If the throttle linkage does not allow the carbure-tor throttle plate (C) to return to idle against idle screw (D),loosenlinkage nuts; turn throttle linkage nut (A) counter clock wiseuntil throttle plate (C) just rests against idle screw (D). Holdlinkage nut (A) from turning and tighten other linkage nut.5. Connect ignition leads (C). SRM-2100 has one connectorterminal pair and one ring terminal which attaches under fanterminal screw (C).6. Install air filter and cover.FRONT HANDLE INSTALLATIONTools Required: Screwdriver.Parts Required: Front Handle, Handle Support, Four (4) 5mm x 35mmscrews with captivated washers, four (4) 5mm nuts.1. Position front handle for comfortable operation and secure screws.AB C D