Echo SRM - 230U Operator's Manual

Also see for SRM - 230U: Operator's manual

28NYLON LINE REPLACEMENTLevel 1.Parts Required: ECHO 0.095" Nylon Trimmer Line 6 m (20 ft.) long.1. Shut engine off. Lay unit on the ground with head assembly up.2. Hold drum (A) and firmly turn spool (B) CW (clockwise) until itdisengages from the inner drive. Pull spool from drum. DO NOTpush in on spool when turning.3. Use one piece of new nylon line (C) 6 m (20 ft.) long and threadthrough the molded loop (D) on the spool. Pull line tight andadjust so one end is 15 cm (6 in.) longer than the other.4. Hold the spool, opening toward you. Place index finger betweenthe two strands and wind line, tightly and evenly, in direction ofarrow (E) marked "CC".5. Stop when approximately 15-20 cm (6-8 in.) line (C) remains andplace ends of line in notches (F) in spool (B).6. Feed ends of line through housing eyelets (G) and place spool (B)over drive (H). Align pegs (I) on drive with notches in spool, andpush spool into drum.7. Pull on both lines until they come free from notches (F) in spool.DIBACGGFFBBBAHECC