4Shaft DecalWARNING DANGER• This unit can be dangerous and cause serious injury if improperly used. Toreduce injury risk to operator, helpers and bystanders, read and understandthe Operator's and Safety manuals.• Blindness can occur from objects that are thrown or ricocheted even withshield in place. Operators, helpers and bystanders must wear ANSI Z87.1approved eye protection.• Always wear hearing protection when operating unit.• Prevent accidental contact with unit and any cutting attachment. Maintain a15M (50 ft.) radius, DANGER ZONE surrounding the operator. ONLY theoperator, dressed in proper protective clothing should be in the DANGERZONE.• Beware of KICKOUT (blade thrust) when using blades. Special precau-tions are necessary for blade operation, see your Operator's and SafetyManuals. ONLY install ECHO approved blades on Brush Cutters (SRM)models equipped with proper blade shield, U-handles, harness, blade collar,nut and cotter pin.• Blade/Cutting attachment does not stop immediately after releasing throttle.Keep hands and feet clear of blade/cutting attachment unless engine is shutoff and cutting attachment is not moving.• INSPECT BLADES BEFORE USE.• DO NOT USE DAMAGED, CRACKED, BENT, DULL OR IMPROP-ERLY SHARPENED BLADES.• Do not remove shields, modify the unit or install attachments or parts notapproved by ECHO. Approved attachment information and replacementOperator's and Safety Manuals are available from your ECHO dealer or bywriting: ECHO, INCORPORATED, 400 OAKWOOD RD., LAKEZURICH, IL 60047.P/N 89016844830INTERNATIONAL SYMBOLSHotSurfaceCarburetorAdjustment- Idle speedCarburetorAdjustment- High speedmixtureDESCRIPTION SYMBOLSYMBOL"WARNING, SEEOPERATOR'SMANUALWear eye, earand headprotectionEmergencyStopFuel and oilmixtureFinger SeveringCarburetorAdjustment- Low speedmixturePrimerBulbIgnitionON/OFFWear hand andfoot protectionSafety/AlertKeep bystanders and helpersaway 15 m (50 ft.).DO NOT smokenear fuel.DO NOT allowflames or sparksnear fuel.DESCRIPTION SYMBOL DESCRIPTION SYMBOL DESCRIPTIONChoke Control"Cold Start"Position(Choke Closed)Choke Control"Run"Position(Choke Open)Do not useblades. Stringline only