Echo SRM - 261SB Operator's Manual

Also see for TRIMMER ATTACHMENT SRM-261SB: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Echo SRM - 261SB Operator's Manual Manual pdf 30 page image

30Drive Shaft (Upper)1. Remove coupler from upper drive shaft assembly by looseningclamping screw (E) and removing set screw (F).2. Remove upper flex drive cable, wipe clean and apply a thin coating15 ml (1/2 oz.) of ECHO® LUBETM.3. Install flex drive cable. Make sure that the flex cable engages into theclutch mount and also into the coupler mount.4. Install set screw (F) and tighten clamping screw (E).NYLON LINE REPLACEMENTLevel 1.Tools required: Head locking tool (if head is to be removed)Parts Required: ECHO 0.095" Nylon Trimmer Line 12 m (40 ft.) long.1. Hold drum (A) and turn spool (B) CW (clockwise) until it stops. Pullspool from drum. DO NOT push in on spool when turning.2. Use one piece of new nylon line (C) 12 m (40 ft.) long and threadthrough the molded loop (D) on the spool. Pull line tight and adjustso one end is 15 cm (6 in.) longer than the other.3. Hold the spool, opening toward you. Place index finger between thetwo strands and wind line, tightly and evenly, in direction of arrowmarked "CC".4. Stop when approximately 15-20 cm (6 - 8 in.) line (C) remains andplace ends of line in notches (E) in spool (B).EF