Echo SRM - 265U Operator's Manual

Grass Trimmer /Brush CuTTer13OperaTOr's manualCAu - handle InstallatIonTools Required: 17 & 19 mm wrench, 4 mm hex socket wrenchParts Required: U-Handle, Clamp w/screws, 8 mm x 55 mm hexbolt,8 mm flat washer1. Install upper U-Handle and bracket on lower bracket with one(1) 8mm x 55mm bolt (A) and (1) large circular washer. Do nottighten bolt securely until final adjustments are completed.2. Loosen upper (2) U-handle clamp screws (B), and position U-handle as shown.3. Lightly tighten 8mm bolt (A) and clamp screws (B) to hold U-handle in position until final adjustments are completed.4. Route throttle linkage and ignition lead assembly along shaft andclip as shown.5. Install throttle linkage cable into fan cover clip (C).Bthrottle lInkage and IgnItIon leads1. Close choke and remove air filter cover.2. Place throttle linkage (A) through adjustment fixture (B) and installwire end into large carburetor throttle swivel hole (C). Checkthrottle for freedom of movement and that wide open throttle / lowidle extremes are adjusted properly. The throttle linkage must beadjusted by moving the adjustment fixture (B). Consult with yourEcho Dealer for correct adjustment procedure.3. Connect 2 ignition stop leads (D,E) from throttle cable tubing to 2ignition leads (D,E) on engine.ABDE FC