Echo SRM-2100SB, SRM-2400SB Operator's Manual

Also see for SRM - 2400SB: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Echo SRM-2100SB, SRM-2400SB Operator's Manual Manual pdf 28 page image

28NYLON LINE REPLACEMENTLevel 1.Tools required: Head locking tool (if head is to be removed)Parts Required: ECHO 0.095" Nylon Trimmer Line 6m (20 ft.) long.1. Shut engine off. Lay unit on the ground with head assembly up.2. Hold drum (A) and turn spool (B) CW (clockwise) until it stops.Pull spool from drum. DO NOT push in on spool when turning.3. Use one piece of new nylon line (C) 6m (20 ft.) long and threadthrough the molded loop (D) on the spool. Pull line tight andadjust so one end is 15 cm (6 in.) longer than the other.4. Hold the spool, opening toward you. Place index finger betweenthe two strands and wind line, tightly and evenly, in direction ofarrow marked "CC".5. Stop when approximately 15-20 cm (6-8 in.) line (C) remains andplace ends of line in notches (E) in spool (B).6. Feed ends of line through housing eyelets (F) and place spool (B)over drive (G). Align pegs (H) on drive with notches in spool andpush spool into drum.7. Pull on both lines until they come free from notches (E) in spool.8. Hold drum (A) firmly and turn spool (B) CCW (counterclockwise)until it stops. DO NOT push in on spool when turning.9. Pull both lines out and trim to cut-off knife length.BBA