Echo SRM-266T Operator's Manual

Also see for SRM-266T: Operator's manual Operator's manual

SRM-266T DESCRIPTION© 6/2013 ECHO Inc.X7502026103 111. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.2. GRIP - Rear (right hand) handle.3. THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttletrigger is prevented unless throttle trigger lockout lever is engaged.4. STOP SWITCH - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switchFORWARD to RUN, BACK to STOP.5. FRONT HANDLE - The Front (loop) handle is loosely assembled to the Drive Shaft assembly and mustbe positioned for proper cutting attitude and operator comfort.6. DRIVE SHAFT ASSEMBLY - Includes the Rear (right hand) Handle assembly, Gear Housing assembly,Front (loop, left hand) Handle assembly, steel drive shaft and Safety Decal.7. NYLON CUTTER HEAD - Contains replaceable nylon trimming line that advances when the trimmerhead is tapped against the ground while the head is turning at normal operating speed.8. CUT-OFF KNIFE - Automatically trims line to the correct length: 5" after head is tapped on the ground. Iftrimmer is operated without a cut-off knife, the line will become too long, the engine will overheat, andengine damage may occur.9. PLASTIC DEBRIS SHIELD ASSEMBLY - Included in plastic bag (co-pack). MUST be installed on unitbefore use, see Assembly Instructions. Shield assembly includes the Cut-Off Knife. Mounts on the GearHousing Assembly just above the cutting attachment. Helps protect the operator by deflecting debrisproduced during the trimming operation. This shield must be replaced with the steel shield for blade use.10. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, presstrigger gradually for best operating technique.11. SPARK PLUG - Provides spark to ignite fuel mixture.12. ARM REST - Provides arm rest during operation and protects arm from the hot engine.13. RECOIL STARTER HANDLE - Pull handle slowly until starter engages, then quickly and firmly. Whenengine starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.14. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITH CATALYST -The muffler orcatalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowingparticles of carbon from leaving the muffler. Keep exhaust area clear of flammable debris.15. FUEL TANK - Contains fuel and fuel filter.16. FUEL TANK CAP - Covers and seals fuel tank opening.17. CHOKE - The choke control is located at the rear of the air cleaner housing. Move choke lever to ColdStart ( ) to close choke for cold start. Move choke lever to “Run” ( ) position to open choke.18. AIR CLEANER - Contains replaceable filter element.19. PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purgingair from the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank returnline. Pump purge bulb an additional 4 or 5 times.