Switching Audio Control ModesBASS MID TREB BAL FAD NON-F NF-P LPF LOUD SVC VOL BASS ...Turn the [VOL] rotary knob to the right or left in the audio mode while referring to the table below to adjust thesound.1 The modes will switch one step in the order shown below each time the [ENTER]button is pressed.Mode Function [VOL] rotary knob/FunctionBASS Adjusts bass level. Turn to the right Emphasises low sounds.Turn to the left Softens low sounds.MID (MIDDLE) Adjusts middle level.Turn to the right Emphasises mid rangesounds.Turn to the left Softens mid rangesounds.TREB (TREBLE) Adjusts treble level. Turn to the right Emphasises highsounds.Turn to the left Softens high sounds.BAL (BALANCE)Adjusts left/rightspeaker balance(BALANCE).Turn to the right Emphasises rightspeakers.Turn to the left Emphasises leftspeakers.FAD (FADER)Adjusts front/rearspeaker balance(FADER).Turn to the right Emphasises frontspeakers.Turn to the left Emphasises rearspeakers.NON-F (NON-FADERLEVEL)Adjusts non-faderlevel (for connectedsub-woofer).Turn to the right Increases the sub-wooferlevel.Turn to the left Decreases the sub-woofer level.NF-P (NON-FADERPHASE)The merger of soundbetween the front andrear speakers and thewoofer can beimproved by selectingthe phase. Switch thephase which lets thespeakers combinewithout anydisharmony.Turn to the rightNORMAL(Makes the output timingof the front/rear speakersand the woofer thesame.)Turn to the leftREVERSE(Changes the phase ofthe output timing of thefront/rear speakers andthe woofer.)