22OperationSwitching the displayEach press of the button swicthes thedisplay the clock and currentfrequency.Changing the receptionsensitivity for automaticscanningThe equipment lets you select the receptionsensitivity to be used for automatic scanning ofstations. The two sensitivity modes available forthis equipment are LOC mode and DX mode.ATTENTIONWhen an optional HD Radio tuner isconnected, reception sensitivity is set to theLOC Mode. The DX Mode is unavailable.(U.S.A. only)The mode switches between LOCmode and DX mode each time thebuttons are pressed.Changing the radio bandlocationThe location for the radio bands used betweenthe North American region and the Asia/Australia/Latin region can be switched. Thedefault setting is USA (North America).ATTENTIONWhen an optional HD Radio tuner isconnected, radio band location is set to USA.Other radio band locations are unavailable.(U.S.A. only)The radio band switches in the ordershown below each time the buttonsare pressed.USA ➔ ASIA ➔ AUS ➔ LATIN➔ USA wwwAfter this, the broadcast stations willbe searched for automatically andstored in the buttons [1] to [6].1 Press the [DISP FUNC] button forless than one second.LOC ModeDuring automatic scanning, thereception sensitivity switchesautomatically to one of two levels.Initially the reception sensitivity isset to the low level so that onlystations with strong signals arereceived. If no stations could bereceived, the reception sensitivity isincreased so that stations withweaker signals can also bereceived.DX ModeBecause the reception sensitivity forautomatic scanning is set to the highlevel from the start, even stationswith weaker signals can be received.(Signal crossover may result insome stations being hard to hear.)1 Check that the equipment is instandby mode.2 Press and hold the [FM AM] button,then the [1] button, and hold bothfor several seconds.1 Check that the equipment is instandby mode.2 Press and hold the [FM AM] button,then the [3] button, and hold bothfor several seconds.
