ESN security operating procedure31VIIWhat happens if an incorrect CD isinserted?After the [HELP] message will appearfor five seconds, serial number willappear.After the [SEC] message appears fortwo seconds, rolling code (six digit) willappear.[DISC] flashes on the display.You will have five more attempts toinsert correct disc.If the correct CD is inserted, an [OK]message will appear for two secondsand the CD will be ejected.ATTENTION• If an incorrect CD is inserted, an [ERR_ ] ("ERR"and error number) message will appear for twoseconds, after which the CD will be ejected.• This process cancels the protection for ESNequipment.How to turn the securityindicator on/offOnce ESN security is activated, the indicatorflashes whenever the vehicle's ignition switch isturned off, warning potential thieves that theequipment is protected. However, if do not wantthis visible deterrent, it may be turned off.[IND. FLASH] means the securityindicator will flash when the vehicle'signition switch is off, and [IND.-----]means it will not. Repeat the abovesteps to reactivate the flash mode.How to read the ElectronicSerial Number[ESN] appears on the display, followedby an eight-digit number; this numberis your electronic serial number (ESN).You may use this number to identifyyour Eclipse CD3000 in the event oftheft recovery.1 After the 5th incorrect attempt, thedisplay reads [HELP] for fiveseconds.2 Press the [CD ] button to closethe front panel.3 Press the [FUNC] button, then thebutton [6], and hold them for fiveseconds.4 Press the [FUNC] button.5 Insert the Key CD into the slot.● Note ●If after 5 tries the correct Key CD is notinserted, the display will read [CALL]; theequipment must be returned to Eclipse tobe reset. In this case, please contact yourEclipse dealer for assistance.Your Key CD can be easily forgotten.Write the album name in a remindernote (See page 63).1 With the equipment in standby,press the [FUNC] button, then thebutton [2] and hold both for morethan one second.2 [IND. FLASH] or [IND.-----] appearson the display.1 Check that the equipment is instandby.2 Press and hold the [FUNC] button,then the button [4], and hold bothfor more than one second.
