Page 22used. Once again the network cables are optional if no remote control is required. Thesequence in which the speakers are linked with the network cable is not relevant for thisapplication.4.2 Digital setup4.2.1 Stereo 2.0 SystemThere are 2 ways to setup a digital 2.0 system. The first one relies on the FAR Link TMnetwork to carry audio and control between the LEFT and the RIGHT speakers. The FARLink TM network cable is then the only link between the 2 speakers. The first speakerautomatically bridge the AES/EBU input to the FAR Link TM network output (Output “AutoSel” setting)ID:Input:Output:Digital Ch.:LEFTAES/EBU1. FRONT LEFTAuto SelAuto SelA(L)ID:Input:Output:Digital Ch.:RIGHT2. FRONT RIGHTAuto SelAuto SelB(R)DIGITAL INNETWORK IN NETWORK OUTNETWORK INThe other option is to use the conventional XLR cables to link the speakers via theDIGITAL OUT / DIGITAL IN connectors. The first speaker automatically bridges theAES/EBU input to the AES/EBU output (Output “Auto Sel” setting) In this case, therewill not be any remote control enabled.