FAR KJ 45/S Instructions For Use Manual

Also see for KJ 45/S: Original instructions TRANSLATION OF ORIGINAL INSTRUCTIONS TRANSLATION OF ORIGINAL INSTRUCTIONS

Contents

GB KJ 45/SKJ 45/S12 Date 07-2016 Revisione - 08INSTRUCTIONS FOR USE IINDEXGUARANTEE ............................................................................. 12SAFETY MEASURES AND REQUIREMENTS ............................. 12TOOL IDENTIFICATION ............................................................. 13GENERAL NOTES AND USE ...................................................... 13MAIN COMPONENTS ................................................................ 13TECHNICAL DATA ..................................................................... 13AIR FEED ................................................................................... 14PRELIMINARY OPERATIONS .................................................... 14PLACING OF THE INSERT ......................................................... 15WORKING PROBLEMS ............................................................. 16CHANGE OF SIZE ..................................................................... 17ADJUSTMENT OF TIE-ROD/HEAD UNIT................................... 18TOOPING UP THE OIL-DYNAMIC CIRCUIT ............................... 19MAINTENANCE ........................................................................ 19DISPOSAL OF THE RIVETING TOOL ......................................... 19CAUTION!!!All the operations must be done in conformitywith the safety requirements, in order to avoidany consequence for your and other peoplesecurity and to allow the best tool work way.• Read the instructions carefully before using the tool.• For all maintenance and/or repairs please contact FAR s.r.l.authorized service centers and use only original spare parts.FAR s.r.l. may not be held liable for damages from defective partscaused by failure to observe what mentioned above (EEC directive85/374).The list of the service centres is available on our websitehttp://www.far.bo.it ( Organization )• The tool must be used only by expert workers.• A protective visor and gloves must be put on when using thetool.• Use equipment recommended in the maintenance chapter to doany maintenance and/or regulation of the tool.• For topping up the oil, we suggest using only fluids in accordancewith the features specified in this working book.• If any drop of oil touches your skin, you must wash with waterand alkaline soap.ATTENTION! In case of strong impacts or accidentalfalls the machine should be completely overhauled.GUARANTEEFAR riveting tools are covered by a 12-month warranty. Thetool warranty period starts on the date of delivery to thebuyer, as specified in the relevant document. The warrantycovers the user/buyer provided that the tool is purchasedthrough an authorized dealer and only if it is used for thepurposes for which it was conceived. The warranty shallnot be valid if the tool is not used or maintained as specifiedin the instruction and maintenance handbook. In the eventof defects or failures, FAR S.r.l. shall undertake solely torepair and/or replace the components it judges to be faulty.SAFETY MEASURES AND REQUIREMENTS• The tool can be carried and we suggest putting it into its box afterusing.• The tool needs a thorough six-monthly overhaul.• Repairing and cleaning operations must be done when the toolis not fed.• A safety balancer is suggested when it is possible.• If the A-weighted emission sound pressure level is more than70 dB (A), you must use some hearing protections (anti-noiseheadset, etc.).• The workbench and the work surface must be always clean andtidy. The untidy can cause damages to people.• Do not allow unauthorized persons to use the working tools.• Make you sure that the compressed air feeding hoses have thecorrect size to be used.• Do not carry the connected tool by pulling the hose. The holemust be far from any heating sources or from cutting parts.• Keep the tools in good conditions; do not remove either safetyparts or silencers.• After repairing and/or adjusting, make sure you have alreadyremoved the adjusting spanners.• Before disconnecting the compressed air hose from the toolmake sure that there is no pressure in the hose.• These instructions must be carefully followed.