FAR KJ 45/S Instructions For Use Manual
Also see for KJ 45/S: Original instructionsTRANSLATION OF ORIGINAL INSTRUCTIONSTRANSLATION OF ORIGINAL INSTRUCTIONS
                                                                                | |
GB KJ 45/SKJ 45/S18 Date 07-2016 Revisione - 08TIE-ROD/HEAD UNIT ADJUSTMENT (fig. f14-f15-f16)Changing the length of the insert to clamp, the position ofthe head (B) compared to the threaded tie rod (A) shouldbe adjusted.Disconnect the compressed air feeding from the tool.Screw an insert of the desired length on the threaded tierod manually until the insert head touches the riveting toolhead (B). The head is adjusted correctly if the threaded tierod comes out of the insert screwed on it of about 2 mm.Otherwise unblock the ring nut (C) with a 22 mm standardspanner then screw or unscrew the head (B) up to the rightposition, and block the ring nut (C).ATTENTION!Disconnect the machine before carrying out theabove-mentioned operations.AB CBf15f16f1422 mmC |
Related manuals for FAR KJ 45/S
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine