Falcon 1092 CKR Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions

Falcon 1092 CKR Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions Manual pdf 15 page image

15For each side, support the side rail with onehand and with the other hand lift the frame upand out of the side clips.For safety, push the side rails back into the grillchamber.The side rails can be removed to make cleaningthe grill chamber easier by unhooking themfrom the grill chamber sides.Slides can be wiped clean with a soft cloth andmild detergent.DO NOT use any abrasive substance.DO NOT put the side runners in thedishwasher.When you have finished, hook the side railsback on to the sides of the chamber. To refitthe frame pull the side rails forward and foreach side in turn, support the side rail andpress the frame down into the side rails.Replace the grill pan.Control Panel and Oven DoorsFor best results liquid detergents should beused.The control panel and control knobs shouldonly be cleaned with a soft cloth wrung out inclean hot soapy water - but take care that nosurplus water seeps into the appliance. Wipewith a clean dampened cloth then polish witha dry cloth. The oven doors should only becleaned with a soft cloth wrung out in cleanhot soapy water.OvensThe shelf supports on the oven sides can beremoved for cleaning.First remove theoven shelves thenpull the top of theshelf support upand away fromthe oven sideand then lift thesupport awayfrom the locatingbracket in theoven side at thebottom.To refit the side support, firstlocate the tag at the bottomof the support in the slot inthe locating bracket in theoven side.Then locate the tops of theside arms in the holes at thetop.The panels on the oven sides are fixed andcannot be removed. They have been coatedwith special enamel that partly cleans itself.This does not stop all marks on the lining, buthelps to reduce the amount of manual cleaningneeded.The Cook & Clean panels work better above200°C. If you do most of your cooking belowthis temperature, occasionally remove the shelfsupports and wipe the panels with a lint freecloth and hot soapy water. The panels shouldthen be dried and the oven heated at 200°Cfor about one hour. This will ensure the Cook &Clean panels are working effectively.Don’t use steel wool (or any other materialsthat will scratch the surface). Don’t use ovencleaning pads.