Falcon 1092 CKR Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions

Falcon 1092 CKR Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions Manual pdf 24 page image

SERVICING - WARNINGDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.24Retighten the hinge screws.Effect of hinge adjustment – exaggerated for clarityCentre line of hinge pinOven door omitted for clarityLoosen the bottom hinge fixing screws and use thenotch and a flat bladed screwdriver to move the positionof the hinge to set the hinge position. Retighten thehinge screws.Effect of hinge adjustment – exaggerated for clarityCentre line of hinge pinOven door omitted for clarityCustomer carePlease inform the user how to operate the cooker andhand over these instructions.Thank you.Conversion to LP GasServicing - warningThis conversion must be performed by a competentperson. After conversion the installation must complywith the relevant regulations and also the localelectricity supply company requirements. Read theinstructions before converting this appliance.Failure to convert the appliance correctly couldinvalidate any warranty or liability claims and lead toprosecution.This instruction must be used in conjunction withthe rest of the appliance instruction, in particularfor information on Standards, cooker positioning,connection hose suitability etc.When servicing or replacing gas-carrying componentsdisconnect from gas before commencing operation andcheck appliance is gas sound after completion.Do not use re-conditioned or unauthorised gas controls.ConversionDisconnect from electricity and gas before servicing.Check appliance is safe when you have finished.This appliance is CAT II 2H3+. It is supplied set for G20natural gas at 20millibarA conversion kit for LP gas is supplied with the cooker.InjectorsRemove pan supports and burner heads.Burner headBrass venturiBurner baseBurner ringUndo the large brass nuts and remove the brass venturisand brass rings.Either:-Use a long box spanner to access and remove theold jets.Or: -* see section 2 “Servicing”Remove hotplate, lift up the front of the hotplatetop and prop it up. The burner bases are nowaccessible - remove the old jets.Save the jets removed from the appliance for possiblefuture use. Fit the new jets, see the table for the correcttype.