Falcon 1092 CT Dual Fuel User's Manual & Installation Instructions

Falcon 1092 CT Dual Fuel User's Manual & Installation Instructions Manual pdf 26 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.22ArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloor3 mm minTypical floor mountingABABArtNo.010-0004 Moving the cookerCookerOuter stabilitybracketFloorWall3 mm minTypical wall mountingA – Outer stability bracket, B – Inner stability bracketFig.7-8Fig.7-9Fig.7-7Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjustingnut (Fig.7-5). Rotate the nut – clockwise to raise – counter-clockwise to lower.Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the cardboard base tray. Open theoven doors so that you can get a good grip on the bottom ofthe fascia panel as you move the oven (Fig.7-6).Carefully push the cooker backwards off the base tray.Remove the base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn DO NOT use the door handles or control knobs tomanoeuvre the cooker.Fitting a Stability BracketFloor FixingAssemble the parts (Fig.7-7).Using suitable screws and fixings, attach the assembledbracket to the floor to give a minimum engagement of 65 mminto the back of the cooker.Adjust and lock the inner stability bracket to give a 3 mmclearance above the engagement edge in the back of thecooker (Fig.7-8).Wall FixingWhere floor fixing is impractical and provided that the outerstability bracket can be attached to a solid wall, the stabilitybracket may be attached to a wall (Fig.7-9). Make sure to usesuitable screws and fixings.Repositioning the Cooker FollowingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7-6), you need to check behind the cooker to make surethat the gas hose is not caught.As you progress, make sure that both the electricity cable andgas hose always have sufficient slack to allow the cooker tomove.With a stability chain fitted, release it as you ease the cooker out.Do not forget to refit it when you replace the cooker.When you replace the cooker, again check behind to makesure that the electricity cable and gas hose are not caught ortrapped.Fig.7-6Fig.7-5