Falcon 1092 Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions

Also see for 1092 Deluxe Dual Fuel: User guide User's guide & installation instructions User's guide & installation instructions User's manual & installation and servicing instructions

Falcon 1092 Dual Fuel Deluxe User's Manual & Installation And Servicing Instructions Manual pdf 23 page image

23LOWER THE FRONT ROLLER by doing 14 complete (360°)turns clockwise. (This means turning and removing thelevelling tool 56 times).Now LOWER THE TWO REAR ROLLERS.First fit the levelling tool on the hexagonal adjusting nutas shown below.Make 10 complete (360°) turns clockwise. (This meansturning and removing the levelling tool 20 times).Make sure you lower BOTH REAR ROLLERS. There aretwo adjusting nuts, one for each roller, at both the frontbottom corners of the cooker.Unfold the rear edge of pack base tray. Carefully pushthe cooker backwards along the hardboard strips andinto position. Take care not to damage the power cable.Push the cooker close to its final position, leaving justenough space to get behind it.Conversion to LPIf the appliance is to be converted to LP gas do theconversion at this point. See the conversion section ofthese instructions.LevellingYou are recommended to use a spirit level on a shelf inone of the ovens to check for level.Place the cooker in its intended position taking care notto twist it within the gap between the kitchen units asdamage may occur to the cooker or the units.The rollers can be adjusted to level the cooker. To adjustthe height of the rear of the cooker use the levelling toolsupplied to turn the adjusting nuts at the front bottomcorners of the cooker.Adjust the height of the front roller to level the cooker.Turn clockwise to raise the cooker and anticlockwise tolower.When you are satisfied with the height and level raisethe front of the cooker by one turn of the front rolleradjuster. Screw down the front feet to meet the floor.Screw the front roller adjuster anticlockwise to raise thefront roller so that the front of the cooker is supportedon the feet, not the front roller, to prevent accidentalmovement of the cooker.Gas ConnectionFitting a stability bracketA stability bracket or chain (not supplied by with thecooker) should be fitted when the cooker is connectedto a flexible gas supply. Any restraining device should besecured to the fabric of the building and should be ableto be released so that the cooker can be pulled out forcleaning and maintenance.When fitting a stability bracket read these instructionstogether with the leaflet supplied with the bracket.a) Position and level the appliance.b) Draw a pencil line 68mm from the front edge of thelevelling feet.