Falcon 110 Dual Fuel Instructions For Use And Installation

Also see for Classic 110 Dual Fuel: User guide & installation & service instructions User guide & installation & service instructions User's guide & installation instructions User guide User's guide & installation instructions

Contents

Falcon 110 Dual Fuel Instructions For Use And Installation Manual pdf 27 page image

English27burning appliances in the same room, more ventilation maybe required.Location of CookerThe cooker may be installed in a kitchen/kitchen diner butNOT in a room containing a bath or shower.NOTE:An appliance for use on Liquid Petroleum Gas must not beinstalled in a room or internal space below ground level e.g.in a basement.You will need the following equipment to complete thecooker installation satisfactorilyRestraining DeviceA restraining device should be fitted when the cooker is con-nected to a flexible gas supply. The cooker manufacture doesnot supply these. Any restraining device should be secured tothe fabric of the building and should be able to be releasedso that the cooker can be pulled out for cleaning and mainte-nance.Gas Pressure TesterFlexible Gas HoseMust be in accordance with the relevant standards.Multimeter(for electrical checks)Positioning the CookerThe diagrams show the minimum recommended distancefrom the cooker to nearby surfaces.ArtNo.110-0004 - 110 Cooker min spacings75 mmmin75 mmmin650 mmmin898 mmmin925 mmmaxArtNo.110-0003 - Min positions above cooker410 mm min1100 mm min***The hotplate surround should be level with, or above, anyadjacent work surface. Above hotplate level a gap of 75mmshould be left between each side of the cooker and any adja-cent vertical surface.For non-combustible surfaces (such as unpainted metal orceramic tiles) this can be reduced to 25mm.A minimum space of 650mm is required between the top ofthe hotplate and a horizontal combustible surface.Any cooker hood should be installed in accordance with thehood manufacturer’s instructions.For safety reasons curtains must not be fitted immediatelybehind the cooker.We recommend a gap of 1110mm between units to allow formoving the cooker. If a flush fit is required, fit the cooker upto the unit at one side then fit the unit the other side.A clearance of 130mm is required if the cooker is near a cor-ner of the kitchen to allow the oven doors to open.Unpacking the CookerDo not take any packaging off the cooker until it is directlyin front of the place it is to be installed (unless it will not fitthrough a door in its outer packaging).Cut the banding straps and lift the cardboard box off thecooker, leaving the cooker standing on the base packaging.See the loose unpacking sheet.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The rollers can be adjusted to level the cooker. To adjust theheight of the rear of the cooker use the levelling tool suppliedto turn the adjusting nuts at the front bottom corners of thecooker.Adjust the height of the front roller to level the cooker. Turnclockwise to raise the cooker and anticlockwise to lower.When you are satisfied with the height and level raise thefront of the cooker by one turn of the front roller adjuster.Screw down the front feet to meet the floor. Screw the frontroller adjuster anticlockwise to raise the front roller so thatthe front of the cooker is supported on the feet, not the frontroller, to prevent accidental movement of the cooker.Leave the levelling tool on the adjuster with the handle of thetool facing the rear of the cooker, so that the customer canuse it if they wish to move the cooker.Replace the drawer by locating on side runners and push in.Fit the Handles (some models only)Remove the 4mm Allen screws from the doors with the hexa-gon key tool. Use the screws to fit the door handles.The handles should be above the fixings.