Falcon Classic Deluxe User's Manual & Installation Instructions

Also see for Classic Deluxe: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User guide & installation & service instructions

Falcon Classic Deluxe User's Manual & Installation Instructions Manual pdf 17 page image

15ArtNo.331-0001Grill pan pulled forwardsArtNo.331-0003 Grill frame out, no panArtNo.331-0004 Removing the grill frameArtNo.331-0005 Removing the grill railArtNo.331-0006 Grill pan planFig.5-5Fig.5-6Fig.5-7Fig.5-8Fig.5-9The GriddleAlways clean the griddle after use. Allow it to cool completelybefore removing. Immerse the griddle plate in hot soapywater. Use a soft cloth or, for stubborn stains, a nylon washingup brush.Note: If the griddle is washed in a dishwasher then somedishwasher residue may appear on the back. This is normaland will not affect the performance of your griddle.Glide-out Grillnn Before you remove any of the grill parts for cleaning.make sure that they are cool, or use oven gloves.The grill pan and trivet should be washed in hot soapy water.Alternatively, the grill pan can be washed in a dishwasher.After grilling meats or any foods that soil, leave to soak fora few minutes in the sink immediately after use. Stubbornparticles may be removed from the trivet by using a nylonbrush.The grill pan can be easily removed for cleaning as follows:Remove the grill pan support frame by pulling the grill panforward (Fig.5-5).Lift the grill pan clear of the support frame. The support frameis held to the side rails by two clips on each side (Fig.5-6).For each side, support the side rail with one hand and withthe other hand lift the frame up and out of the side clips(Fig.5-7).For safety, push the side rails back into the grill chamber.If you need to remove the side rails to allow cleaning of thegrill chamber, you can unhook them from the grill chambersides (Fig.5-8) and wipe the sides clean with a soft cloth andmild detergent.DO NOT put the side runners in a dishwasher.Once you have finished, hook the side rails back onto thesides of the chamber. To refit the frame, pull the side railsforward and, for each side in turn, support the side rail andpress the frame down into the side rails.Replace the grill pan. When refitting the grill pan, make surethat the wide rim is at the front (Fig.5-9).Control Panel and DoorsAvoid using any abrasive cleaners including cream cleaners.For best results, use a liquid detergent.The same cleaner can be used on the doors, or alternatively,using a soft cloth wrung out in clean hot soapy water – buttake care that no surplus water seeps into the appliance.After cleaning, polish with a dry cloth.