Falcon Elan 110 Dual Fuel User's Manual & Installation Instructions

Also see for Elan 110 Dual Fuel: User guide & installation & service instructions User guide

Falcon Elan 110 Dual Fuel User's Manual & Installation Instructions Manual pdf 29 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.25ArtNo.010-0004 Moving the cookerFig.7-6Fig.7-5Fig.7-3Fig.7-4Moving the Cookernn On no account try and move the cooker while it isplugged into the electricity supply.nn The cooker is very heavy, so take great care.We recommend that two people manoeuvre the cooker.Make sure that the floor covering is firmly fixed, or removed,to prevent it being disturbed when moving the cookeraround.To help you, there are two levelling rollers at the back, andtwo screw-down levelling feet at the front.Remove the polystyrene base pack. From the front, tiltthe cooker backwards and remove the front half of thepolystyrene base (Fig.7-3). Repeat from the back and removethe rear half of the polystyrene base.Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjusting nut(Fig.7-4).Rotate the nut – clockwise to raise – counter-clockwise tolower. Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the cardboard base tray. Open thegrill door and right-hand oven door so that you can get agood grip on the bottom of the fascia panel as you move theoven (Fig.7-5).Carefully push the cooker backwards off the base tray.Remove the base tray.Position the cooker close to its final position, leaving justenough space to get behind it (Fig.7-6).nn DO NOT use the door handles or control knobs tomanoeuvre the cooker.Levelling the CookerIt is recommended that you use a spirit level on a shelf in oneof the ovens to check for level.Place the cooker in its intended position. Take care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker use a 13 mmspanner or socket wrench to turn the hexagonal adjustingnuts at the front bottom corners of the cooker.To set the front turn the feet bases to raise or lower.