Falcon Elan 110 Dual Fuel User's Manual & Installation Instructions

Also see for Elan 110 Dual Fuel: User guide & installation & service instructions User guide

Falcon Elan 110 Dual Fuel User's Manual & Installation Instructions Manual pdf 34 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.30ABCArtNo.311-0010 InjectorsFig.8-1A – Jet, B – Internal injector, C – External injectorArt No 215-0028 - Handrail fascia fixingsFig.8-2Conversion from Natural Gas (1.0 kPa)to LPG X Propane (2.75 kPa)nn A suitably competent person must perform theconversion. After conversion the installation mustcomply with the relevant regulations and also thelocal electricity supply company requirements. Readthe instructions before converting this appliance.nn Failure to convert the appliance correctly couldinvalidate any warranty or liability claims and leadto prosecution.nn When servicing or replacing gas-carryingcomponents disconnect from the gas supply beforestarting operation. Check the appliance is gas soundafter completion.nn DO NOT use reconditioned or unauthorised gascontrols.nn Disconnect from the electricity and gas supplybefore servicing.nn Before electrical reconnection, check that theappliance is electrically safe.InjectorsRemove the burner caps and heads. Remove the old jets(Fig.8-1). Fit the new jets (see the ‘Technical Data’ section at theback of this book for the correct jets). Reassemble in reverseorder.Tap AdjustmentRemoving the Control PanelRemove the handrail. Now remove the 2 cross-headed screwshidden behind the handrail end brackets (Fig.8-2).Pull off all the control knobs and remove the fixing screwsunderneath the control panel.Lift the control panel and pull forwards, taking care not todamage or strain the wiring.#Bypass Screw AdjustmentTurn the bypass screw on each control clockwise to the stop(Fig.8-3).Refit the control panel.8. Conversion to LP GasArtNo.0102-0011 - Screwingthe control valve bypass screwFig.8-3