Falcon Mercury 1082 Induction User's Manual & Installation Instructions

Also see for Mercury 1082 Induction: User's guide & installation instructions

10ArtNo.324-0009 Tall oven shelfArtNo.324-0010 Plate warming shelfFig.2-18Fig.2-16 Fig.2-17Fig.2-19Fig.2-20 Fig.2-21Fig.2-22Fig.2-25Fig.2-24AccessoriesOven ShelvesThe cooker is supplied with the following:Left-hand Oven1 standard shelf (Fig.2-16)1 drop shelf (Fig.2-17)1 telescopic shelf with runners (Fig.2-18)1 set of side supports (Fig.2-19)Right-hand Oven4 flat cooking shelves (Fig.2-20)1 plate warming shelf (Fig.2-21)1 set of side supports (Fig.2-22)To Remove and Refit the ShelvesThe shelf has a small kink on either side (Fig.2-23). To removethe shelf, line these up with the stops in the shelf support(Fig.2-24). Lift the shelf upwards so that it will pass over theshelf stop and then pull it forwards (Fig.2-25).Refit in the reverse order, making sure to push it fully back.To Remove and Refit the Telescopic Shelf and RunnersSlide the shelf out on the runners. While holding one of therunners securely, carefully lift the rear of the shelf upwards:the shelf will spring clear of the central restraining tab. Repeatfor the opposite side of the shelf.Note: To aid the removal of the shelf you can insert a suitableflat tool through the opening in the side of the runners andlever the shelf clear (Fig.2-26).Tilt the front of the shelf downwards and then lift clear of therunners (Fig.2-27).Refit in the reverse order, making sure to push the shelf downonto the runner arms.To Remove and Refit the Ladder Shelf SupportsLift the ladder support hooks out of the two locating holes inthe oven side (or divider) before lifting the support clear ofthe bottom ladder restraint.Refit by inserting the bottom of the ladder into the restraintbefore fitting the hooks through the locating holes.Oven Shelves – Right-hand (Tall) OvenWhen using the tall oven, you can cook on all four shelves atthe same time, but make sure that they are well spaced outallow the hot air to circulate.Fig.2-23Fig.2-27Fig.2-26