Falcon Mercury 1082 Induction User's Manual & Installation Instructions

Also see for Mercury 1082 Induction: User's guide & installation instructions

INSTALLATIONCheck the appliance is electrically safe when you have finished.21ArtNo.010-0004 Moving the cookerFig.7-6Fig.7-5Fig.7-8Fig.7-7Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjustingnut (Fig.7-5). Rotate the nut – clockwise to raise – counter-clockwise to lower.Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the pack base tray. Open the grilldoor and right-hand oven door so that you can get a goodgrip on the bottom of the fascia panel as you move the oven(Fig.7-6).Carefully push the cooker backwards off the pack base.Remove the pack base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn DO NOT use the door handles or control knobs tomanoeuvre the cooker.Fitting the Flue and VentFitting the FlueRemove the four screws from the grill flue opening.Offer the removable flue up to grill flue opening. Making surethat the removable flue bottom flange fits inside the fixedflue, secure in place with the four screws (Fig.7-7).Fitting the Flue VentLoosen the three screws in the back of the hotplate. Fit theflue vent over the screws and slide down (Fig.7-8). Tightenthe screws to secure.