Falcon Professional + User Manual & Installation & Service Instructions

Also see for Professional +: User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Falcon Professional + User Manual & Installation & Service Instructions Manual pdf 21 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.19Fitting a stability bracketA stability bracket or chain (not supplied by with the cooker)should be fitted when the cooker is connected to a flexiblegas supply.When fitting a stability bracket read these instructionstogether with the leaflet supplied with the bracket.ArtNo.110-0010 Fitting the stability bracket�� A - Levelling rollers, B - Levelling feet, C - Wall face,D - Pencil line on the floorArtNo.020-0013 Stability bracket1. Place the cooker in its intended position and level it.2. Draw a pencil line 100mm from the front edge of thelevelling feet.3. Mark the centre line for the bracket by measuring550mm from the left-hand side of the cooker.4. Lower the front roller and move the cooker forward.5. Measure back from the pencil line 550mm to locate thefront edge of the bracket. Fix the bracket to the floor.6. Measure the height from floor level to engagementedge in back of cooker. Add 3mm to this dimension andassemble the stability bracket to this height. (i.e. fromfloor level to underside of the top member) and ensurethe bracket does not foul the oven burner assembly.Gas ConnectionMust be in accordance with the relevant standards. A hose isnot supplied by with the cooker. Hoses may be purchased atmost builders’ merchants.The Gas supply needs to terminate with a down facingbayonet. The rear cover boxes limit the position of the supplypoint.Because the height of the cooker can be adjusted andeach connection is different it is difficult to give precisedimensions. Ideally the house supply bayonet should be inthe shaded area shown in the diagram. Although a 900mmhose can be used, a 1250mm hose will allow slightly moreflexibility in the positioning of the bayonet and make movingthe cooker easier. The hose should be fitted so that both inletand outlet connections are vertical so that the hose hangsdownwards.The connector is located just below the hotplate level at therear of the cooker.ArtNo.110-0011 110 DF gas hose connections��A - Appliance gas inlet , B - Position for gas supply connector;alternatively, connect it from the side For Natural Gas the flexible hose must be inaccordance with B.S.669. For LP Gas it should be capable of 50mbar pressure,70°C temperature rise and carry a red stripe, band orlabel.If in doubt contact, your supplier.Screw connect the threaded end of the hose into the gas inletin the underside of the connector block on the back of thecooker.After completing the gas connection, check the cooker is gassound with a pressure test.Pressure testingThe gas pressure can be measured at one of the centrehotplate burner injectors (not the Wok burner). Lift off aburner head and fit the pressure gauge to the injector. Turnon and light one of the other hotplate burners. Turn on thecontrol knob for the burner with the pressure gauge fitted tolet gas through.PressuresNatural Gas LP Gas cookers20mbar Butane 29mbarPropane 37mbarTurn off the burners. Reassemble burner top, making sure it isreassembled in the correct way on the burner body.