37EnglishPull the shelf forwarduntil the back of the shelfis stopped by the shelfstop bumps in the ovensides.Lift up the front of theshelf so the back of theshelf will pass under theshelf stop and then pullthe shelf forward.To refit the shelf, line up the shelf with a groove in the ovenside and push the shelf back until the ends hit the shelf stop.Lift up the front so the shelf ends clear the shelf stops, andthen lower the front so that the shelf is level and push it fullyback.SteamWhen cooking foods with high water content (e.g. ovenchips) there may be some steam visible at the grille at therear of the hotplate. This is perfectly normal.Oven lightPress the appropriate button to turn on the oven light.If the oven light fails, turn off the power supply beforeyou change the bulb. See the ‘Troubleshooting’ section fordetails on how to change an oven light bulb.StorageThe drawer can get very warm, don’t store anything in it thatmay melt or catch fire.The drawer can be removed completely for cleaning etc.To remove the drawer pull it forward.Lift up the ends of the plastic clips (one each side) to releasethe catches holding the drawer to the side runners and atthe same time pull the drawer forward and away from theside runners.For safety’s sake push the drawer runners back out of theway.To refit the drawRest the drawer back on the side runners and, keeping itlevel, push it right back. The clips should click into positionholding the drawer to the side runners.Cleaning your cookerEssential informationBefore thorough cleaning isolate the electricity supply.Remember to switch on the electricity supply and reset theclock before using the cooker.Never use paint solvents, washing soda, caustic cleaners,biological powders, bleach, chlorine based bleachcleaners, coarse abrasives or salt. Don’t mix differentcleaning products - they may react together withhazardous results.Recommended cleaning materials are shown in the‘Cleaning Table’ at the end of this section.All parts of the cooker can be cleaned with hot soapy water -but take care that no surplus water seeps into the appliance.Hotplate burnersSome models have a separate trim ring, which fits on theburner head.The burner heads and caps can be removed for cleaning.Make sure they are absolutely dry before replacing.