20Anti-theft systemRemove the panel1. Press the PWR button to turn the power off.2. Press OPEN button to detach the panel.3. Pull the panel out.4. Place the panel into the case and take it with you when you leave the car.Remove the unit1. Remove the panel and the trim plate.2. Insert both T-Keys into hole on the front of the set until they lock.3. Pull out the unit.NOTE:The source unit will turn off if the control panel is open longer than 60 seconds.The LED light on the inner panel will twinkle in red when the ACC power is cut off.Handling & Cleaning DISCHandling- Dirty, scratched or warped discs may cause skipping or noise.- To keep the disc clean, only handle the disc by its edges.- Discs should be stored in their cases after use to avoidscratches.- Do not expose discs to direct sunlight, high humidity, hightemperature or dust.- Prolonged exposure to extreme temperature can warp thedisc (such as leaving the discs in your car in summer heat).- Do not stick or write anything on either side of disc. Sharp writing instruments, or the ink usedin some felt-tip pens, may damage its surface.- Do not touch the unlabelled side. Do not attach any seal, label or data protection sheet toeither side of a disc.Cleaning DISCFingerprints should be carefully wiped from the surface of discwith a soft cloth. Unlike conventional records, compact discshave no grooves to collect dust or dirt, so gently wiping themwith a soft cloth should remove most dust or stains. Wipe in astraight motion from the centre to the edge.CAUTION: Never use thinner benzene, record cleaner or anti-static spray on a compact disc.Such chemicals can damage its plastic surface.