Farmet DUO Operating Manual
                                                | |
Contents
| 
OPERATING MANUALOILSEED SCREW PRESS FARMET DUOPage 25 of 486. OPERATION OF THE EQUIPMENT6.1 INSPECTION OF THE OPERATING VALUES AND PARAMETERSThe Equipment may work continuously with regular inspections provided that a regularfeed of material has been ensured.Many problems and defects may be prevented by regular inspection rounds, duringwhich you should check: Noise, vibrations – increase in noise, banging, creaking or vibrations may signal wearor malfunction – of bearings and other components. If such a noise is present, try toidentify its location and inform your service technician, or the Producer’s service. Temperature – The press warms up significantly during pressing (by friction of thepressing bodies) but its operating temperature stabilizes (it depends on the ambienttemperature and the temperature and humidity of the pressed material). If there is anincrease in temperature, inform your service technician or the service centre. If thehigher temperature is caused by a high temperature in the press shop, provide betterventilation or decrease the pressing capacity (decrease revolutions).6.2 BREAKDOWNIn case of an unnaturally loud noise coming from the Equipment (banging,creaking, blows) or in case of smoke or any other dangerous situation, immediatelystop the material feed. If there is a risk of injury of the employees or damage to theproperty or the Equipment, immediately stop the Equipment, contact the servicecentre.The Equipment may only be activated again after the cause of the breakdownhas been identified and removed.Please, contact the service centre in case of any uncertainties or unknown failures. Thecontact information is provided on the title page of the Operating Manual.6.3 SUDDEN STOP OF THE PRESSIf during the press operation suddenly stop due to overload, do the following: Stop the flow of seeds in the press Let press to cool for several minutes Unscrew the nozzle and start the press shortly In the event that the press does not rotate, remove the nozzle holder and press shortlystart |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine