Federal FCC-4 Installation & Operation Instructions

Also see for FCC-4: Installation & operation instructions

Contents

Federal FCC-4 Installation & Operation Instructions Manual pdf 12 page image

CAUTION: Do not use alcohol based or solvent cleaners on the frontglass.CAUTION: Do not use alcohol based or solvent cleaners on the frontglass.Interior Cleaning1. Remove rear doors from track by lifting door upward until the bottom of the door clears thelower door track and then outward. Remove the inner door in the same manner.2. Remove all shelves from the case by sliding them rearward and through the door opening.3. Unplug the shelf lights and lift one end then the other off the shelf brackets then throughthe door opening.4. Remove the shelf brackets from the shelf standards.5. Open the tilt-out front glass.6. Open the door for the rear storage area.7. Clean the entire interior of the case using warm soapy water. Wipe off all soapy water witha damp cloth and allow to dry.Note: Depending on the amount of usage and spillage of foreign material, some fasteners mayhave to be removed and parts disassembled to allow proper cleaning of the unit.8. Clean all shelves, shelf brackets, and shelf light housings using warm soapy water and abrush. Rinse thoroughly and allow to dry.9. Clean all foreign material from inner and outer rear door tracks using warm soapy waterand a brush. Apply a light film of lubricant, such as PAM, to make the doors operatesmoother.10. Clean both sides of the doors and interior of the front glass using any common windowcleaner.Exterior Cleaning1. Clean the front glass using any common window cleaner.2. The exterior surfaces should be wiped down using any ammoniated cleansers or warmsoapy water.